Skip to main content

Laboratory tests


Dengue fever may be diagnosed by microbiological laboratory testing.[23] This can be done by virus isolation in cell cultures, nucleic acid detection by PCR, viral antigen detection or specific antibodies (serology).[13][25] Virus isolation and nucleic acid detection are more accurate than antigen detection, but these tests are not widely available due to their greater cost.[25] All tests may be negative in the early stages of the disease.[5][13]

These laboratory tests are only of diagnostic value during the acute phase of the illness with the exception of serology. Tests for dengue virus-specific antibodies, types IgG and IgM, can be useful in confirming a diagnosis in the later stages of the infection. Both IgG and IgM are produced after 5–7 days. The highest levels (titres) of IgM are detected following a primary infection, but IgM is also produced in secondary and tertiary infections. The IgM becomes undetectable 30–90 days after a primary infection, but earlier following re-infections. IgG, by contrast, remains detectable for over 60 years and, in the absence of symptoms, is a useful indicator of past infection. After a primary infection the IgG reaches peak levels in the blood after 14–21 days. In subsequent re-infections, levels peak earlier and the titres are usually higher. Both IgG and IgM provide protective immunity to the infecting serotype of the virus. In the laboratory test the IgG and the IgM antibodies can cross-react with other flaviviruses, such as yellow fever virus, which can make the interpretation of the serology difficult.[7][13][26] The detection of IgG alone is not considered diagnostic unless blood samples are collected 14 days apart and a greater than fourfold increase in levels of specific IgG is detected. In a person with symptoms, the detection of IgM is considered diagnostic.

Comments

Popular posts from this blog

DENGUE FEVER , HEALTH EDUCATION , INFECTION CONTROL (ICSP) , URDU

Clinical course

The characteristic symptoms of dengue are sudden-onset fever, headache (typically located behind the eyes), muscle and joint pains, and a rash. The alternative name for dengue, "break-bone fever", comes from the associated muscle and joint pains.[1][7] The course of infection is divided into three phases: febrile, critical, and recovery.[8] The febrile phase involves high fever, often over 40 °C (104 °F), and is associated with generalized pain and a headache; this usually lasts two to seven days.[7][8] At this stage, a rash occurs in approximately 50–80% of those with symptoms.[7][9] It occurs in the first or second day of symptoms as flushed skin, or later in the course of illness (days 4–7), as a measles-like rash.[9][10] Some petechiae (small red spots that do not disappear when the skin is pressed, which are caused by broken capillaries) can appear at this point,[8] as may some mild bleeding from the mucous membranes of the mouth and nose.[5][7] The fever itself is cl...

Virology

Dengue fever virus (DENV) is an RNA virus of the family Flaviviridae; genus Flavivirus. Other members of the same family include yellow fever virus, West Nile virus, St. Louis encephalitis virus, Japanese encephalitis virus, tick-borne encephalitis virus, Kyasanur forest disease virus, and Omsk hemorrhagic fever virus.[11] Most are transmitted by arthropods (mosquitoes or ticks), and are therefore also referred to as arboviruses (arthropod-borne viruses).[11] The dengue virus genome (genetic material) contains about 11,000 nucleotide bases, which code for the three different types of protein molecules (C, prM and E) that form the virus particle and seven other types of protein molecules (NS1, NS2a, NS2b, NS3, NS4a, NS4b, NS5) that are only found in infected host cells and are required for replication of the virus.[12][13] There are four strains of the virus, which are called serotypes, and these are referred to as DENV-1, DENV-2, DENV-3 and DENV-4.[2] All four serotypes can cause th...